For Brightsign Compact HD410, 810 & 1010

RFID 'Pico Adapter Module'

!Preliminary!

RFID_PAM  'Pico Adapter Module'  for use with 'Pico Transponders'

This module connects to RFID boards using 8-wire telephone cable.

Features:

• Small footprint (3.0 x 2.0 inches)
• RFID Pico Adapter Module (PAM)
• Two RJ45 connections for 'daisy chain of modules'
• Two Diagnostic Modes Selectable on board
• On board LED's to indicate Processor running and address detect
• Multiple Transponder Modules (up to 15) can be connected to a single RFID board
• Output Terminal Block for up to 8 lamp (LED) connections
• Note: The Pico module needs a 12 pin header and the 12 pin header will be shipped with this board.

Link: Pico RF Module Pico RF Adapter Modules by Heddier Electronics

Diagnostic Modes:

Address Selection:

One dip switch (switch 1) on the board selects up to 15 transponder addresses. 

• Switch 1-      4       3        2      1
• Address 1    Off    Off    Off    On
• Address 2    Off    Off    On    Off
• Address 3    Off    Off    On    On
• Address 4    Off    On    Off    Off
• Address 5    Off    On    Off    On
• Address 6    Off    On    On    Off
• Address 7    Off    On    On    On

BrightSign to Roku_C_RFID Protocol:  See Roku_C_RFID specification sheet.

BrightSign to RFID Interface Protocol Recap:

Roku_C_RFID to Transponder Modules Protocol:

Note: All Transponders require an 'HMS Adapter' board for the transponder mounting and communication to the RFID interface board.

Updated: December 21, 2011